Now consider the ease and simplicity of using a gauge block. This phenomena is called parallax and occurs regularly when reading rulers. If not dead level, reading will be either too great or too small. Second, you’ll need to bend over and view the measurement with your eye dead level to the ruler at the measurement mark your trying to read. First, most plunge routers offer little space to insert a ruler to take the reading and at best, the corner of the ruler is all that’s resting on the depth stop. This is a difficult reading to take for a couple reasons. A ruler is then used to measure, then adjust, the distance between adjustment rod and depth stop. First, the bit is set until the tip touches the surface of the router is resting on. Often, further adjustment is necessary.Ī second method for setting depth of cut involves the use of the router’s depth stops and adjustment rod. ![]() Then a series of bit adjustments are made (awkwardly, I should add) until they are ready to make a test cut. Some woodworkers will make an approximate setting then try to measure it by bridging over the router base to the tip of the bit using a combination square. Say you want to set the depth of cut on a plunge router. There are a number of reasons setup blocks are superior. Hands down, they beat more traditional measuring devises like rulers and tape measures. Using gauge blocks (sometimes called setup blocks) can eliminate the often tedious process of getting a saw blade or router bit set precisely. These precision-machined blocks are perfect for your table saw, router table, drill press, band saw and other shop equipment. ![]() Woodworking machine setup is often most easily accomplished using gauge blocks. Use Gauge Blocks for Fast, Accurate Woodworking Machine Setups
0 Comments
Leave a Reply. |